Important Notes About Selecting The System Default Gateway - Ruckus Wireless SmartCell Gateway 200 Getting Started Manual

Important Notes About Selecting the System Default
Gateway
Depending on your network topology, you may select either the Management or
Control interface as the system default gateway.
• If all of the managed APs are located in different locations on the Internet, the
controller may not know all of the IP subnets of these APs. In this case, the
control interface should be set as the default system gateway of the controller
and you will need to add a static route to reach the management network.
• If all of the managed APs belong to a single subnet or to multiple subnets on
which you can set the route statically, then you can set the management interface
as the default gateway users can set default system gateway of the controller
and set static routes for the controller to reach all of its managed APs.
SmartCell Gateway 200 Getting Started Guide for SmartZone 3.5.1, 800-71517-001 Rev A
Running the Setup Wizard and Logging On to the Web Interface
Step 2: Configure the Management IP Address Settings
46