Powering On The Scg - Ruckus Wireless SmartCell Gateway 200 Getting Started Manual

Smartzone 3.5.1

Hide thumbs Also See for SmartCell Gateway 200:

Table of Contents

Figure 13. Securing the server to the rack

Congratulations! You have completed mounting the SCG onto your server rack.

Powering On the SCG

The SCG supports both AC and DC power. Refer to the relevant section below for

instructions on how to power on the SCG.

•

Using AC Power

•

Using DC Power

Using AC Power

NOTE:

The AC power cable (part number 902-0174-XX00, where XX is the two-

character country code) is not supplied with the SCG appliance and may be ordered

separately.

Follow these steps to use AC to supply power to the SCG.

1 Connect the AC power cable to the primary power socket (right) on the rear

panel. Optionally, connect a second AC power cable to the backup power socket

(left) on the rear panel.

SmartCell Gateway 200 Getting Started Guide for SmartZone 3.5.1, 800-71517-001 Rev A

Mounting and Powering the SCG

Powering On the SCG

Table of Contents

Do you have a question about the SmartCell Gateway 200 and is the answer not in the manual?

Scg200