Ruckus Wireless SmartCell Gateway 200 Getting Started Manual page 59

Table 12. New zone settings
Field
AP Firmware (Zone)
Country Code (Zone) Indicates the country code. Using the
Location
Location Additional
Information
GPS Coordinates
AP Admin Logon
AP Time Zone
AP IP Mode (Zone)
Configuration > Mesh Options (Zone)
Enable Mesh
Networking
SmartCell Gateway 200 Getting Started Guide for SmartZone 3.5.1, 800-71517-001 Rev A
Description
Indicates the firmware to which it
applies.
When you create a new zone,
Note:
there is no Change button. A fresh
installation of SCG does not contain
all the other versions in the drop
down list. Only for an upgrade, the
user can choose from a drop down
list containing all the AP firmware.
However, Ruckus recommends that
you install the latest firmware
version.
correct country code helps ensure
that APs use only authorized radio
channels.
Indicates the generic location of the
zone.
Indicates the detailed location of the
zone.
Indicates the geographical location.
Indicates the admin logon credentials. Enter the Logon ID and Password.
Indicates the time zone that applies. Select a time zone, and then enter
Indicates the IP version that applies. Select the IP version.
Indicates if mesh networking is
enabled.
Configuring the SCG for the First Time
Your Action
Select the firmware.
Select the country code.
Enter the location.
Enter additional location information.
Enter the following coordinates:
• Longitude
• Latitude
• Altitude
the details as required.
Select the check box and enter the
following:
• Mesh Name
• Mesh Passphrase
Creating an AP Zone
59