If This Controller Is Forming A New Cluster - Ruckus Wireless SmartCell Gateway 200 Getting Started Manual

If This Controller Is Forming a New Cluster

Follow these steps if you want to use this controller to create a new cluster.
1 On the Cluster Information page, configure the following settings:
• Cluster Setting: Select New Cluster.
• Cluster Name: Type a name that you want to assign to this new cluster.
• Controller Name: Type a name for the controller in this new cluster. The
Controller/Node name can be different for each.
• Controller Description: Type a description for the controller.
• NTP Server: Type the address of the NTP server from which members of the
cluster will obtain and synchronize time. The default NTP server is
pool.ntp.org.
• AP Conversion: Select the check box if you want ZoneFlex APs that are in
factory default settings to be converted to SmartZone APs automatically
when they are connected to the same subnet as the controller.
CAUTION!
cluster is created, you will be unable to edit its settings without rebuilding the cluster
from scratch.
2 Click Next to continue to the next Setup Wizard page. The Administrator page
appears.
3 On the Administrator page, configure the web interface and CLI passwords. All
fields are required.
• Admin Password: Type a password that you want to use to access the web
interface.
• Confirm Password: Retype the password above to confirm.
• Enable Password: Type a password that you want to use to enable CLI
access to the controller.
• Confirm Password: Retype the password above to confirm.
4 Click Next to continue. The Confirmation page appears and displays all the
controller settings that you have configured using the Setup Wizard.
Continue to
SmartCell Gateway 200 Getting Started Guide for SmartZone 3.5.1, 800-71517-001 Rev A
Before continuing, verify that the cluster settings are correct. Once the
Step 5: Verify the Settings.
Running the Setup Wizard and Logging On to the Web Interface
Step 4: Configure the Cluster Settings
49