Table Of Contents - Ruckus Wireless SmartCell Gateway 200 Getting Started Manual

Table Of Contents

Limitation Of Liability2
About This Guide6
Document Conventions7
Documentation Feedback8
Preparing To Set Up The Smartcell Gateway9
Unpacking The Controller10
Rack Mount Kit Contents11
Before You Begin13
Get To Know The Physical Features Of The Controller14
Rear Panel17
Mounting The Scg Onto A Server Rack22
Step 2: Separate The Slide Rails Into The Inner And Outer Parts23
Step 3: Install The Outer Rail Slides To The Rack Posts24
Step 4: Fasten The Shoulder Screws To The Server25
Step 5: Install The Inner Rails On The Server26
Step 7: Attach The Mounting Ears To The Rail Assembly27
Powering On The Scg28
Using Dc Power30
Preparing The Scg Interface Settings To Use34
Preparing The Administrative Computer35
Overview Of The Scg Setup Wizard38
Step 2: Configure The Management Ip Address Settings41
Important Notes About Selecting The System Default Gateway46
Step 3: Configure The Data Plane Ip Address Settings47
Step 4: Configure The Cluster Settings48
If This Controller Is Forming A New Cluster49
If This Controller Is Joining An Existing Cluster51
Step 5: Verify The Settings52
Connecting Data Blades To The Network53
Logging On To The Web Interface54
Setup Wizard55
Creating An Ap Zone57
Configuring Aaa Servers And Hotspot Settings67
Creating A Hotspot (Wispr) Service70
Creating A Registration Rule73
Configuring The Rule Priority74
Defining The Wlan Settings Of A Zone75
General Options76
Authentication Options77
Accounting Server (Standard Usage)79
Guest Access Portal80
Hotspot 2.0 Profile81
Radius Options82
Advanced Options83
Verifying That Wireless Clients Can Associate With A Managed Ap86
Is Lwapp2Scg Enabled On The Controller89
Method 1: Perform Auto Discovery Of The Controller Using The Ap Registrar90
Important Notes91
Subnet92
Method 4: Configure Dhcp Option 43 On The Dhcp Server95
Method 5: Manually Configure The Controller Address On The Ap's Web Interface98