Ruckus Wireless SmartCell Gateway 200 Getting Started Manual page 45

6 Check the network settings that you have configured on the Control, Cluster,
and Management tabs and the default gateway that you have selected. Verify
that they are all correct.
7 Click the Apply to continue. The controller validates and applies the network
settings that you have configured.
Figure 24. The controller validates and applies the network settings you have configured
CAUTION!
an error message appears after you apply the network interface settings, wait at
least 15 minutes, and then try again.
NOTE: If the controller is unable to validate the network settings that you configured,
an error message appears. If this happens, check the network settings that you
configured and verify that you are able to connect to the IP address that you assigned
to the Management (Web) interface.
8 Update the IP address settings of the administrative computer with the same
subnet settings that you assigned to the Management (Web) interface
(see Step
Continue to
SmartCell Gateway 200 Getting Started Guide for SmartZone 3.5.1, 800-71517-001 Rev A
It may take the controller up to 15 minutes to activate its interfaces. If
4).
Step 3: Configure the Data Plane IP Address
Running the Setup Wizard and Logging On to the Web Interface
Step 2: Configure the Management IP Address Settings
Settings.
45