Step 4: Configure The Cluster Settings - Ruckus Wireless SmartCell Gateway 200 Getting Started Manual
Smartzone 3.5.1
Hide thumbs
Also See for SmartCell Gateway 200:
- Command line interface reference manual (583 pages) ,
- Reference manual (384 pages) ,
- Getting started manual (99 pages)
Table of Contents
Advertisement
Step 4: Configure the Cluster Settings
The actions that you need to perform in this step depends on whether you are
creating a new cluster (with this controller as the first node) or you are setting up
this controller to join an existing cluster.
•
If This Controller Is Forming a New Cluster
•
If This Controller Is Joining an Existing Cluster
NOTE:
A SmartCell Gateway (SCG) 200 unit can only form a cluster with other
SmartCell Gateway 200 units. It cannot join a cluster of SmartZone (SZ) 100 units
(and vice versa).
Figure 26. The Cluster Information page
SmartCell Gateway 200 Getting Started Guide for SmartZone 3.5.1, 800-71517-001 Rev A
Running the Setup Wizard and Logging On to the Web Interface
Step 4: Configure the Cluster Settings
48
Advertisement
Table of Contents
Need help?
Do you have a question about the SmartCell Gateway 200 and is the answer not in the manual?