Ruckus Wireless SmartCell Gateway 200 Getting Started Manual page 65

Table 12. New zone settings
Field
Status LEDs
LLDP
Port Settings
Configuration > Advanced Options
Note: Select the Override check box for that setting, and then configure the setting.
Channel Mode (Zone) Indicates if location-based service is
Auto Channel
Selection
Background Scan
(Zone)
SmartCell Gateway 200 Getting Started Guide for SmartZone 3.5.1, 800-71517-001 Rev A
Description
Disables the status LED on the
selected AP model.
Enables the Link Layer Discovery
Protocol (LLDP) on the selected AP
model.
Indicates the port settings.
enabled. If you want to allow outdoor
APs that belong to this zone to use
wireless channels that are Channel
Mode regulated as indoor-use only,
select the Allow indoor channels
check box.
Indicates auto-channel settings.
Runs a background scan.
Configuring the SCG for the First Time
Your Action
Select the option to disable the
status LED.
Select the option and enter the
following details:
• Advertise Interval—Enter the
duration in seconds.
• Hold Time—Enter the duration in
seconds.
• Enable Management IP TLV—
Select the check box.
Select the option and choose the
required LAN option.
Select the check box and choose the
option.
Select the check box and choose the
option.
Select the respective check boxes
and enter the duration in seconds:
• Background Scanning—Changes
the AP channel if there is
interference.
• ChannelFly—Continuously
monitors potential throughput and
changes the AP channel to
minimize interference and
optimize throughput.
Creating an AP Zone
65