Method 5: Manually Configure The Controller Address On The Ap's Web Interface - Ruckus Wireless SmartCell Gateway 200 Getting Started Manual

Figure 39. Enter accept {MAC address} if you only want specific APs to be managed by the
controller
8 Reset the AP to factory default settings, and then connect it to a network subnet
where it can communicate with the controller.
9 Reboot the AP.
After the AP reboots, it will obtain an IP address and the IP address of its parent
controller from the DHCP server. Once the AP registers with the controller, it will
download and install the latest SCG-AP firmware.
You have completed
Method 5: Manually Configure the Controller
Address on the AP's Web Interface
1 Log on to the AP's web interface.
2 Go to the Administration > Management page.
3 In Primary Controller Address, type the IP address of the controller that you want
to manage the AP.
4 In Secondary Controller Address, type the IP address of a backup controller that
you want to manage the AP if the primary controller is unavailable.
5 Click Apply.
You have completed manually configuring the controller's IP address on the AP's
web interface.
SmartCell Gateway 200 Getting Started Guide for SmartZone 3.5.1, 800-71517-001 Rev A
Ensuring That APs Can Discover the Controller on the Network

Method 5: Manually Configure the Controller Address on the AP's Web Interface

98