Mitsubishi Electric MELSEC iQ-F FX5 Programming Manual page 77

Instruction symbol Description
When [(s3)+1, (s3)] = 0: 0  [(d)+1, (d)]
DZONE
When [(s3)+1, (s3)] > 0: [(s3)+1, (s3)] + [(s2)+1, (s2)]  [(d)+1, (d)]
DZONEP
When [(s3)+1, (s3)] < 0: [(s3)+1, (s3)] + [(s1)+1, (s1)]  [(d)+1, (d)]
DZONE_U
DZONEP_U
■Scaling 16-bit/32-bit binary data (point coordinates)
Instruction symbol Description
SCL Executes scaling using the scaling conversion data (16-bit data units) specified by (s2) for the input
value specified by (s1), and then stores the result in the device specified by (d).
SCLP
The scaling conversion is executed based on the scaling conversion data stored in the device
specified by (s2) onwards.
SCL_U
SCLP_U
DSCL Executes scaling using the scaling conversion data (32-bit data units) specified by (s2) for the input
value specified by (s1), and then stores the result in the device specified by (d).
DSCLP
The scaling conversion is executed based on the scaling conversion data stored in the device
specified by (s2) onwards.
DSCL_U
DSCLP_U
■Scaling 16-bit/32-bit binary data (XY coordinates)
Instruction symbol Description
SCL2 Executes scaling using the scaling conversion data (16-bit data units) specified by (s2) for the input
value specified by (s1), and then stores the result in the device specified by (d).
SCL2P
The scaling conversion is executed based on the scaling conversion data stored in the device
specified by (s2) onwards.
SCL2_U
SCL2P_U
DSCL2 Executes scaling using the scaling conversion data (32-bit data units) specified by (s2) for the input
value specified by (s1), and then stores the result in the device specified by (d).
DSCL2P
The scaling conversion is executed based on the scaling conversion data stored in the device
specified by (s2) onwards.
DSCL2_U
DSCL2P_U
Special timer instruction
■Teaching timer
Instruction symbol Description
TTMR
(s)=0:1, (s)=1:10, (s)=2:100
T
ON
■Special function timer
Instruction symbol Description
STMR The 4 points from the bit device specified by (d) operate as shown below, depending on the ON/
OFF status of the input conditions for the STMR instruction:
(d)+0: Off delay timer output
(d)+1: One shot after off timer output
(d)+2: One shot after on timer output
(d)+3: On delay and off delay timer output
)  (s) (d)
(T
ON
: On time of TTMR
Reference
Page 562
Reference
Page 564
Page 567
Reference
Page 570
Page 573
Reference
Page 576
Reference
Page 578
3 CPU MODULE INSTRUCTION
3.3 Application Instruction
3
75