Mitsubishi Electric MELSEC iQ-F FX5 Programming Manual page 613

Operation error
Error code
(SD0/SD8067)
Axis 1 Axis 2 Axis 3
SD5510 SD5550 SD5590
1810H
2820H
3600H
3631H 3632H 3633H
3641H 3642H 3643H
3651H 3652H 3653H
3661H 3662H 3663H
Description
Axis 4
SD5630
The axis number specified by (d) is used by another instruction.
The value specified by (s) is outside the following range.
0 to 65535
The value specified by (n) is outside the following range.
0 to 65535
The value specified by (d) is outside the following range.
0 to 3
The axis number specified by (d) is not set by parameters.
A function which is set to be not used by parameters (such as interrupt input signal 1 and zero return
relations) is used.
3634H The numbers of pulses (by the pulses conversion) of the positioning address specified by (n) exceed the 32-
bit range.
3644H The numbers of pulses (by the pulses conversion) of the command speed specified by (s) exceed the 32-bit
range.
3654H The operation decelerates and stops by the forward limit or reverse limit during the pulse output or at the
activating of the positioning.
3664H The operation decelerates and stops by the pulse output stop command or special relay whose all outputs
are disabled during the pulse output or at the activating of the positioning.
8 APPLICATION INSTRUCTION
8.17 Pulse Related Instruction
8
611