Mitsubishi Electric MELSEC iQ-F FX5 Programming Manual page 668

• Sorting result when the instructions are executed with (n3) = K3 (column No. 3)
Number of data (n1) = 5
Precautions
• Do not change the contents of operands and data during operation.
• To execute these instructions again, set the command input to off once, then on again.
• These instructions can only be used once in any program.
• When specifying the same device in (s) and (d), the source data is overwritten by the data acquired by sorting. Take special
care so that the contents of (s) are not changed until execution is completed.
Operation error
Error code Description
(SD0/SD8067)
1811H These instructions are used more than once.
2820H The device range specified by (s) exceeds the corresponding device range.
The device range specified by (d) exceeds the corresponding device range.
3405H The value specified by (n1) is outside the following range.
1 to 32
The value specified by (n2) is outside the following range.
1 to 6
The value specified by (n3) is outside the following range.
1 to (n2)
8 APPLICATION INSTRUCTION
666
8.22 Data Operation Instruction
Number of groups (n2 = K4)
Column No. 1
Control number
Line No. 1 (d)
4
Line No. 2 (d)+1
1
Line No. 3 (d)+2
2
Line No. 4 (d)+3
5
Line No. 5 (d)+4
3
Column No. 2 Column No. 3
Height Weight
(d)+5 (d)+10
1 0 0 2 0
(d)+6 (d)+11
1 5 0 4 5
(d)+7 (d)+12
1 8 0 5 0
(d)+8 (d)+13
1 5 0 5 0
(d)+9 (d)+14
1 6 0 7 0
Column No. 4
Age
(d)+15
8
(d)+16
2 0
(d)+17
4 0
(d)+18
4 5
(d)+19
3 0