Mitsubishi Electric MELSEC iQ-F FX5 Programming Manual page 574

Setting item
Number of coordinate points
X coordinate Point 1
Point 2
Point 3
Point 4
Point 5
Point 6
Point 7
Point 8
Point 9
Point 10
Y coordinate Point 1
Point 2
Point 3
Point 4
Point 5
Point 6
Point 7
Point 8
Point 9
Point 10
*1 When coordinates are specified using three points as shown in the points 4, 5 and 6, the output value can be set to an intermediate
value.
In this example, the output value (intermediate value) is specified by the Y coordinate of the point 5.
Even if the X coordinate is the same at three points or more, the value at the second point is output.
*2 When coordinates are specified using two points as shown in the points 8 and 9, the output value is the Y coordinate at the next point.
In this example, the output value is specified by the Y coordinate of the point 9.
Operation error
Error code Description
(SD0/SD8067)
3405H The Xn data is not set in the ascending order in the data table.
However, the instructions before the occurrence of an error are executed.
The input value specified by (s1) is out of the range for the set scaling conversion data.
The value in the middle of operation exceeds the 32-bit data range.
In this case, verify that the distance between points is not "65535" or more.
If the distance is "65535" or more, reduce the distance between points.
The number of coordinate points from the device specified by (s2) is 0 or less.
8 APPLICATION INSTRUCTION
572
8.12 Data Control Instruction
Setting device and setting contents
When R0 is specified in (s2)
(s2) R0
(s2)+1 R1
(s2)+2 R2
(s2)+3 R3
(s2)+4 R4
(s2)+5 R5
(s2)+6 R6
(s2)+7 R7
(s2)+8 R8
(s2)+9 R9
(s2)+10 R10
(s2)+11 R11
(s2)+12 R12
(s2)+13 R13
(s2)+14 R14
(s2)+15 R15
(s2)+16 R16
(s2)+17 R17
(s2)+18 R18
(s2)+19 R19
(s2)+20 R20
Remarks
Setting details
K10
K5
K20
K50
*1
K200 Refer to .
K200
K200
K250
*2
K350 Refer to .
K350
K400
K7
K30
K100
*1
K25 Refer to .
K70
K250
K90
*2
K90 Refer to .
K30
K7