Mitsubishi Electric MELSEC iQ-F FX5 Programming Manual page 577

Setting item Setting device and setting contents
When R0 is specified in (s2)
Number of coordinate points (s2)+1, (s2)
X coordinate Point 1 (s2)+3, (s2)+2
Point 2 (s2)+5, (s2)+4
Point 3 (s2)+7, (s2)+6
Point 4 (s2)+9, (s2)+8
Point 5 (s2)+11, (s2)+10
Point 6 (s2)+13, (s2)+12
Point 7 (s2)+15, (s2)+14
Point 8 (s2)+17, (s2)+16
Point 9 (s2)+19, (s2)+18
Point 10 (s2)+21, (s2)+20
Y coordinate Point 1 (s2)+23, (s2)+22
Point 2 (s2)+25, (s2)+24
Point 3 (s2)+27, (s2)+26
Point 4 (s2)+29, (s2)+28
Point 5 (s2)+31, (s2)+30
Point 6 (s2)+33, (s2)+32
Point 7 (s2)+35, (s2)+34
Point 8 (s2)+37, (s2)+36
Point 9 (s2)+39, (s2)+38
Point 10 (s2)+41, (s2)+40
*1 When coordinates are specified using three points as shown in the points 4, 5 and 6, the output value can be set to an intermediate
value.
In this example, the output value (intermediate value) is specified by the Y coordinate of the point 5.
Even if the X coordinate is the same at three points or more, the value at the second point is output.
*2 When coordinates are specified using two points as shown in the points 8 and 9, the output value is the Y coordinate at the next point.
In this example, the output value is specified by the Y coordinate of the point 9.
Operation error
Error code Description
(SD0/SD8067)
3405H The Xn data is not set in the ascending order in the data table.
However, the instructions before the occurrence of an error are executed.
The input value specified by (s1) is out of the range for the set scaling conversion data.
The value in the middle of operation exceeds the 32-bit data range.
In this case, verify that the distance between points is not "65535" or more.
If the distance is "65535" or more, reduce the distance between points.
The number of coordinate points from the device specified by (s2) is 0 or less.
Setting details
R1, R0 K10
R3, R2 K5
R5, R4 K20
R7, R6 K50
R9, R8 K200
R11, R10 K200
R13, R12 K200
R15, R14 K250
R17, R16 K350
R19, R18 K350
R21, R20 K400
R23, R22 K7
R25, R24 K30
R27, R26 K100
R29, R28 K25
R31, R30 K70
R33, R32 K250
R35, R34 K90
R37, R36 K90
R39, R38 K30
R41, R40 K7
Remarks
*1
Refer to .
*2
Refer to .
*1
Refer to .
*2
Refer to .
8 APPLICATION INSTRUCTION
8.12 Data Control Instruction
8
575