Huawei IAD108A User Manual page 51

User Manual
U-SYS IAD108 Integrated Access Device
Configuration steps are as follows.
1) Run Telnet program on the maintenance terminal, set its
terminal type as VT-100/ANSI and the buffer size as 1000,
as shown in Figure 3-8.
Figure 3-8 Set Telnet terminal preferences
Note:
The default Telnet buffer size is small, and you can increase the buffer size properly
so that more history commands can be displayed on the screen. Recommended
buffer size is 1000 lines.
2) Enter the IP address "172.21.100.16" of IAD108 on the
maintenance terminal, and then establish the connection.
3) After connecting IAD108, input correct user name and
password to log in the equipment to load software or
configure data.
Chapter 3 Loading Software
3-9