Huawei IAD108A User Manual page 72

User Manual
U-SYS IAD108 Integrated Access Device
Note:
When loading files through the serial port by using Xmodem protocol, it takes a
long time. Please wait patiently, and do not reboot the system.
To speed up the loading speed, you can use command baudrate to set the
communication rate to 115200 bit/s, and set the communication rate of console
to 115200 bit/s too. Otherwise, the communication will fail.
During the rebooting of the system after the loading is finished, the serial port
speed will be automatically recovered to 9600 bit/s.
4) After the files are completely sent, the following information
will be displayed.
IAD2000#
OPERATION TYPE:
FILE TYPE:
OPERATION STAGE:
PROCESS:
OPERATION TYPE:
FILE TYPE:
OPERATION RESULT:
FAILURE REASON:
IAD2000#
5) If you need to load other files, repeat steps 2 and 3. The
loaded file can only take effect after the system is rebooted.
To reboot the system, you can execute the command
reboot in privilege mode.
Chapter 3 Loading Software
Load operation
Packet file
save file
92%
Load operation
Packet file
Operation complete
Vacancy
3-30