Huawei IAD108A User Manual page 112

User Manual
U-SYS IAD108 Integrated Access Device
mgcip |
mgc-domain-name }
The configuration result can be check by using command show
mg attribute in user mode.
Caution:
IP address of the IAD108 should be configured before configuring MG attribute. To
do this, carry out command ip address ip-address net-mask def-gateway in global
config mode. If the IP address is configured later than the MG attribute, the IAD108
will register to the MGC again.
For the data that should be kept consistent on the IAD108 and MGC, refer to Table
4-2.
II.
Parameter descriptions
The parameters of the commands used to configure MG
attribute are listed in Table 4-12.
mgcport mgcport
Chapter 4 Configuring Data
|
4-36
mgc-domain-name