Huawei IAD108A User Manual page 165

User Manual
U-SYS IAD108 Integrated Access Device
Item
Set whether to send a temporary response. When A sends a
command to B, if the command execution takes a long time, B will
ProvRspFla send a temporary response to A, confirming that it has received the
gVal command. This reduces the possibility for A to resend the
command. The two values are 0 (false) and 1 (true), and the default
value is 1.
The duration set for the temporary response, from the point when B
ProvRspTi receives A's command to the point when it sends the temporary
merVal response. This value cannot be larger than 5 seconds, and the
default value is 2 seconds.
The duration set for the temporary response delay. This value must
ProvRspDe be smaller than 30 seconds, and the default value is 5 seconds.
layVal When A receives the temporary response, it prolongs the
MaxRetranTimer by a duration of ProvRspDelayval.
Note:
All the above parameters are optional. When a parameter is not checked, it means to
adopt the default value. It is recommended to modify these parameters with caution.
Either A or B can be MGC or IAD108.
Example:
Set the maximum retransmission time as 20 seconds, and disable
the at_most_once function.
IAD2000(config)#mgcp maxRetranTimer 20 atMostOnceflag 0
{ <cr>|RetranTimerSeedFlag<K>|RetranTimerSeed<K>|RetranS
uspicionThreshold<K>|Ret
ranDisconnectThreshold<K>|ProvRspFlag<K>|ProvRspTimer<K>
Description
5-28
Chapter 5 Advanced
Configuration