User Manual
U-SYS IAD108 Integrated Access Device
IADMS0:
not configured
IADMS1:
IADMS address
IADMS host name
Use IADMS name to register : No
Get community
Set community
Trap community
Trap port
Register to IADMS while booting
--------------------------------------------------
Handshake interval
Handshake switch
--------------------------------------------------
Register state
IAD2000(config)#
Note:
When adding an IADMS, you must ensure that the IP address of the IADMS is
unique.
Command iadms can either be used to add an IADMS, or modify an IADMS.
The character string of a community name is case-sensitive, which means the
same character strings with different cases will be regarded as different
community names.
After the IADMS is configured, you need to activate it by using command iadms
iadms-num register enable.
Chapter 4 Configuring Data
: 210.11.123.33
:
: get
: set
: trap
: 162
: 30sec
: on
: failed
4-32