Huawei IAD108A User Manual page 60

User Manual
U-SYS IAD108 Integrated Access Device
1) Connect the serial ports of maintenance terminal and
IAD108 through a serial port cable, and then turn on the
HyperTerminal.
2) Reboot the system (through command reboot), and the
following interface will be displayed.
IAD2000>enable
IAD2000#configure terminal
IAD2000(config)#reboot
The config data has been changed, config will be lost
if reboot, continue? [Y|N]:y
Are you sure to reset system? [Y|N]:y
System will reboot in 5 seconds!
Press 't' to Test SDRAM :
Starting...
Init LAN switch ok.
******************************************************
*
Ltd.
******************************************************
*
BIOS version:
Creation date:
auto-booting...
HUAWEI
Copyright 2002-2005 Huawei Technology. Co.,
Chapter 3 Loading Software
IAD2000 SYSTEM
503
Jun 8 2004, 16:38:15
3-18
BOOT