Huawei IAD108A User Manual page 106

User Manual
U-SYS IAD108 Integrated Access Device
identifies the IAD108 by this ID. After that, you can add other
information for this IADMS.
I.
Command modes
In global config mode, you can use the following commands to
configure the equipment ID and add an IADMS.
eid Equipment-ID
iadms
trapcommunity [ nmsTrapPort ]
II.
Descriptions of parameters
Table 4-8 Parameters of the commands used to add an IADMS
Item
Equipment-ID
iad ms-num
ip
getcommunity/
setcommunity
nmsTrapPort
iadms-num
Unique ID of the IAD used in IADMS, it is character string
ranging 1–32 characters.
Number of IADMS, ranging 0–1.
IP address of IADMS
Names of the GET/SET communities of the IADMS. The
GET/SET community names can be any character string less
than 15 characters. A community name is a simple security
guarantee mechanism provided by Simple Network
Management Protocol (SNMP), which is similar to user
password. The IAD108 shall decide whether to accept an NM
request by comparing the GET/SET community name
configured on itself and that configured on the IADMS. By
default, the GET community name is "public" and the "SET"
community name is "private", and you can change the
community names by yourself.
Trap port number used by the IADMS, which is 162 by default.
Chapter 4 Configuring Data
ip getcommunity
Description
4-30
setcommunity