Huawei IAD108A User Manual page 136

User Manual
U-SYS IAD108 Integrated Access Device
IAD2000(config)#spc add start 6 50000 10.70.10.26 50004
name ipspc
Adding SPC succeeded! The SPC index is: 1.
IAD2000(config)#
After the IP SPC is successfully established at IAD108A, the
system returns index "1".
IAD108B(config)#spc add start 1 50004 10.70.33.62 50000
name ipspc
Adding SPC succeeded! The SPC index is: 0.
IAD108B(config)#
After the IP SPC is successfully established at IAD108B, the
system returns index "0".
3) After the configuration is finished, check the configuration
results on IAD108A and IAD108B.
On IAD108A, operate as follows:
IAD2000(config)#show spc
{ <cr>|connectid<K>|from-connectid<K> }:
Command:
------------------------------------------------------
-
index
0
1
IAD2000(config)#
show spc
state type
Normal IAD-SPC
Fault IP-SPC
Chapter 4 Configuring Data
Port Port name
1 3 iadspc
6 - ipspc
4-60