Huawei IAD108A User Manual page 238

User Manual
U-SYS IAD108 Integrated Access Device
V.
Query by Alarm Class
Command: show alarm record alarmclass class [startnum
number]
You can use this command to query alarms by alarm class.
The meanings of the parameters in the command are listed in
Table 7-14.
Table 7-14 Parameters of command
Item
Alarm class. There are three classes: event alarm, fault alarm and
Class recovery alarm. It is only necessary to input the English word
indicating the corresponding class directly.
The alarm number from which the display starts, the value range is
1–1000. In the Command Line Interface (CLI), you can start the
startnum
display from 1, or from a designated startnum.
Maximum number of alarm records after the startnum that can be
number
displayed in one time. It is an optional parameter, ranging 1–1000.
VI.
Query by Alarm Generation Time
Command:
timebegin dateend timeend [ startnum number ]
You can use this command to query the alarms generated within
a certain time segment.
The meanings of the parameters in the command are listed in
Table 7-15.
show alarm
7-50
Chapter 7 Maintaining System
Description
record alarmtime datebegin