Huawei IAD108A User Manual page 114

User Manual
U-SYS IAD108 Integrated Access Device
Parameter
transfer
III.
Usage example
Example: Configure the MG data as follows.
Domain name of the MG interface as "huawei.com"
MG domain name as "iad108.com"
MG interface name as "aaln"
IP address of MGC as "210.11.180.18"
Other parameters adopt the system's default values.
IAD2000(config)#mg
local-name
210.11.180.18
{ <cr>|port<K>|mgcport<K>|code<K>|transfer<K> }:
Command:
local-name
210.11.180.18
IAD2000(config)#
After the configuration has been finished, you can use the
command show in user mode to check the configuration result.
IAD2000(config)#show mg attribute
-------------------------------------------------
Transmission protocol type, which can be Transmission
Control Protocol (TCP), User Datagram Protocol (UDP) or
Simple Control Transmission Protocol (SCTP). MGCP only
supports UDP. The system's default is UDP.
attribute
aaln mgc-domain-name
mg attribute
aaln mgc-domain-name
4-38
Chapter 4 Configuring Data
Description
domain-name
huawei.com
domain-name
huawei.com
iad108.com
mgcip
iad108.com
mgcip