Huawei IAD108A User Manual page 92

User Manual
U-SYS IAD108 Integrated Access Device
Note:
hostname is used to identify the device in the network and can be configured
randomly.
In usual cases, it is configured according to the customer's requirements. If there is
no requirements, it is recommended to name it in the following format:
Hostname = office name + MG type
*office name = country + city + location + operator name
Example: Configure an IAD for Huawei:
Hostname: SZ-BT-HW-IAD108
phone: 0755-12345678.
IAD2000#configure terminal
IAD2000(config)#banner incoming
Please input location name(<20 chars): SZ-BT-HW-IAD108
Please
0755-12345678
Hostname config success
IAD2000(config)#write
Command executing, please wait...
System starts to save configuration data, please wait a
moment......
The configuration data backup percent is: 100%
After configuration, log in the device again. The information of
this office configured just now will be shown in the prompt.
IAD2000(config)#reboot
Are you sure to reset system? [Y|N]:y
input phone
Chapter 4 Configuring Data
number(example:010-88888888):
4-16