Huawei IAD108A User Manual page 102

User Manual
U-SYS IAD108 Integrated Access Device
I.
Configuring System Time for This Device
You can use the command clock set hh:mm:ss yyyy-mm-dd in
global config mode to set the system time for this device. Before
setting the system time, you can use the command show clock in
user mode to check whether the system time is correct.
Example:
Show the system time.
IAD2000>show clock
--------------------------------------------------
System startup date: 2004-08-12 time: 11:01:59
Current date: 2004-08-12
Current time: 11:54:16
--------------------------------------------------
IAD2000>
Modify the system time to 2003-07-11, 15:30:01.
IAD2000(config)#clock set 12:10:10 2004-08-12
Current date: 2004-08-12
Current time: 12:10:10
IAD2000(config)#
II.
Starting SNTP Client
To start the SNTP client on IAD108, you need to execute the
following three commands:
sntp server {address server-ip | name server-name}
sntp time-zone sign value
sntp interval interval-seconds
Chapter 4 Configuring Data
4-26