Huawei IAD108A User Manual page 170

User Manual
U-SYS IAD108 Integrated Access Device
Total ports : 2 PSTN_PORT
SLIC3 State : Normal
Total ports : 2 PSTN_PORT
Equipment ID
RTC CHIP
ENVIRONMENT CHIP: Not Exist
REMOTE POWER
--------------------------------------------------
IAD2000(config)#
In the above results of the show version command, the
subboard type in line "xDSL Board PCB version" is displayed as
"APU.1". The information indicates that the CSP board has been
installed with the ADSL subboard.
In the above results of the show device command, the uplink
mode in line "Up-link state" is displayed as "ADSL". The information
indicates that the ADSL uplink mode is in use.
The ADSL subboard has three functions:
ATM connection
Internal Ethernet
PPP dialing
The ADSL subboard is connected to the network through two
interfaces. One interface connect the DSLAM through the ATM uplink
of the subboard. The other interface connects the uplink Ethernet port
of the IAD through the Ethernet port of the subboard.
I.
ATM Connection
To connect the DSLAM through a subboard, first configure the
ATM attribute on the ADSL subboard.
: 00-e0-fc-03-02-01
: Not Exist
: Supported but unused
6-4
Chapter 6 ADSL Service
Configuration