Huawei IAD108A User Manual page 260

User Manual
U-SYS IAD108 Integrated Access Device
Current time: 09:27:53
--------------------------------------------------
IAD2000#
V.
Showing IP Address and Route Information
When a network fault occurs, you need to show the following
information. Use the four commands specified in Table 8-1 to locate
the fault.
Table 8-1 Common commands to show information on network faults
Showing IP address
Showing route information
Incorrect route information may lead to interface
faults, monologs, or communication failures.
Showing ARP entry in IAD
VI.
Showing RTP Statistical Information
You can carry out the show rtp stat command to show
information on media stream.
IAD2000(config)#show rtp stat 2/6
The parameters displayed by this command have the following
meanings as listed in
Function
Chapter 8 Troubleshooting
IAD2000>show ip address
IAD2000#show ip route
IAD2000>show arp entry
8-4
Command