Connecting The Satellite Router To The Customer's Computer; Printing The System Information Page - Hughes HX90 Installation Manual

Connecting the satellite router to the customer's computer

Printing the System Information page

Use an Ethernet cable to connect the router to the customer's computer as shown in
Figure 48. You can connect to either of the two LAN ports on the rear panel of the
satellite router. Verify that the customer can browse the Internet
Connect to
LAN port.
Computer or
Ethernet device
Figure 48: Connecting the HX90 to the customer's computer
You (the installer) are required to stay at the installation site until the customer can
connect to the Internet so you can offer assistance if necessary.
After you have installed and registered the satellite router, verify that the customer
can browse the Internet. If the customer cannot browse the Internet:
1. Configure the installer laptop so its network properties match those of the
customer's computer.
2. Connect the installer laptop to the satellite router with an Ethernet cable.
3. Open a web browser on the installer laptop.
4. Try to access the router's System Control Center by typing in the browser's
address bar:
www.systemcontrolcenter.com
Enter
5. Press .
6. If the router is functioning, the System Control Center appears.
7. Type
www.hughes.com
Enter
and press .
If the site appears, the router is functioning. The customer should refer to the
contact information (click
Help page for technical assistance.
This section applies to consumer installations only.
Ethernet
cable
RESCUE SWITCH
DC IN
S
AT.
IN
S
AT.
OUT
Router
rear panel
or
192.168.0.1
or some other known site in the browser address bar
Contact Information
Chapter 5 • Completing the installation
2 LAN ports
Use either one.
.
) on the System Control Center
1039456-0001 Revision A
63