Powering Up The Router; Ac/Dc Power Supply; Dc/Dc Power Supply - Hughes HX90 Installation Manual

Powering up the router

AC/DC power supply

DC/DC power supply

Connect and assemble the DC/DC power supply as follows:
1. Connect the DC power cord to the DC IN port on the router.
Note: The input cable kit is included in the power supply kit. The cable kit
contains an input power connector, connector pins, and a wiring diagram;
it does not include wire.
2. Assemble the input power cable according to the wiring diagram included in the
cable kit.
3. Connect the input power cable to the DC power source, but do not connect the
input power connector to the power supply at this time.
Do not connect the input power connector to the power supply until you are
ready to observe the router's LEDs upon power-up, as explained in LEDS on
power-up on page 28.
Check Power supply information on page 15 to make sure you have the correct
power supply. Follow these instructions to power up the router for the first time.
Prerequisites:
• The power outlet has been tested, as described in Connecting an AC/DC power
supply on page 25.
• According to previous instructions, the DC power cord is connected to the
router's rear panel, and the AC power cord is connected to the power supply.
1. Connect the AC power cord into the surge protector or wall outlet.
2. Observe the LEDs for proper operation. See LEDS on power-up on page 28.
Prerequisites: The DC power cord is connected to the router's rear panel, and the
input power cable is assembled and connected to the DC power source.
1. Connect the input cable connector to the power supply.
2. Observe the LEDs for proper operation. See LEDS on power-up on page 28.
Chapter 3 • Installing the satellite router
1039456-0001 Revision A
27