Cli Interface; Quick Reference; Table 18: Cli - Command Summary - Redline RDL-3000 SC User Manual

RDL-3000 FAMILY

4 CLI Interface

This section describes the procedures for configuring and operating the RDL-3000 using
CLI over a Telnet connection. The following procedures require a PC equipped with a
Web browser, Ethernet port, and an Ethernet Cat-5e crossover cable for connection to
the PoE power adapter. The IP address and subnet mask of the PC must be on the
same subnet as the RDL-3000.
For example:

4.1 Quick Reference

Online help is available for all commands, and the Tab key can be used for auto-
complete functions. The following table lists all RDL-3000 commands available from root
mode (default mode when you login).
Command
apply
arp
chgver
clear
del
enable
disable
freq
generate
get
load
logout
new
ping
reboot
reset
save
script
set
show
snmpcommunity
snmptrap
upgrade
user
whoami
70-00158-01-08
USER MANUAL
IP address = 192.168.25.11, Net Mask =

Table 18: CLI - Command Summary

Description
Activate changes without overwriting saved configuration.
Add a static ARP definition to the RDL-3000 ARP table.
Change default version of firmware and reboot.
Clear commands.
Delete an ID.
Enable an ID.
Disable an ID.
Enter frequency ranges for autoscan and DFS.
Create DSA key for SSH locally on RDL-3000.
Display the value of a statistic or parameter.
Load commands.
End the current Telnet session.
Create a new ID.
Send a ping message from the RDL-3000 system.
Reboot the RDL-3000.
Reset the RDL-3000 statistics values.
Save the selected configuration settings.
Generate a configuration script.
View/modify a system parameter value.
View system compound objects (e.g., configuration).
View/modify the SNMP community settings.
View/modify the SNMP trap settings.
Upload a firmware binary image to the RDL-3000.
View/modify the user/password configuration.
Display login name for this Telnet session.
Proprietary Redline Communications © 2011
Chapter 5
255.255.255.0
Page 97 of 150 December 7, 2011