Page 2
All rights reserved May 15, 2015. The information in this document is proprietary to Redline Communications Inc. This document may not in whole or in part be copied, reproduced, or reduced to any medium without prior consent, in writing, from Redline Communications Incorporated.
Edge INSTALLATION GUIDELINES Chapter 1 Important Notices Deployment Information IMPORTANT: Refer to the RDL-3000 Family User Manual for detailed regulatory information. Refer to this document before deploying and powering RDL-3000 family systems in the field. Service & Safety General Warnings Redline recommendations for maximum safety include the following: ...
The RDL-3000 system shall be installed according to local Electrical Safety Codes. For Canadian installations, the entire equipment installation must comply with the Canadian Electrical Code. For installations in the United States, the entire equipment installation must be in accordance with Article 810 of the United States National Electrical Code.
- 57.0 VDC), which must be electrically isolated from any AC sources and reliably connected to Earth ground. Do not install Redline products near any type of power line. Should the antenna or related hardware come in contact with power lines, severe bodily...
All External Circuits TNV-1 as defined in EN 60950-1 All equipment must be grounded Le RDL-3000 du matériel a été testé pour la conformité aux normes de sécurité électriques indiquées dans le tableau suivant: Table 2: Avis: Spécifications de sécurité électrique...
The grounding wire should be connected to the same termination point used for the tower or mast. Provide direct grounding connections from the RDL-3000 system, the mounting bracket, and the antenna to the common building ground bus. Use the grounding screws provided for terminating the ground wires.
Redline does not endorse or support the use of outdoor cable assemblies: i) not supplied by Redline, ii) third-party products that do not meet Redline's cable and connector assembly specifications, or iii) cables not installed and weatherproofed as specified in the RDL-3000 Installation Guidelines manual for each product model.
Chapter 2 System Features System Components The RDL-3000 Edge wireless terminal (subscriber) is designed and manufactured by Redline Communications, a world leader in design and production of outdoor wireless TCP/IP transport for mission critical applications. Figure 2: Features: Redline System Components...
ClearView NMS Application The Edge can be configured and monitored using the SNMP-based Redline ClearView NMS. The Redline Management Suite is a set of applications designed to assist provisioning, monitoring and administration of the Redline components deployed in Radio Access Networks (RANs). Contact your Redline representative or visit the Redline website for further information about the Redline ClearView NMS application.
Long Reset If the IP address, username or password of the Edge is unknown, use the 'long reset' procedure to access the Web or Telnet interface: Refer to the RDL-3000 Family Users Guide for a detailed description of this operation.
Enter a valid permanent or temporary options key in the Options Key 1 field. Click Activate to enable the new features (does not require reboot). Telnet may also be used to install an options key. Refer to the RDL-3000 Family User Manual for a description of the commands.
Step 1: Assemble Ethernet and RF Port Connections Assemble Ethernet Port Connection The Redline outdoor Ethernet cable is terminated with a non-hooded RJ-45 connector. This connects to the metal RJ-45 connector located on the wireless terminal enclosure. When connecting the outdoor Ethernet cable to the wireless terminal, ensure the RJ-45 plug is fully inserted and locked into the socket.