Redline RDL-3000 SC User Manual page 110

RDL-3000 FAMILY
3 - AES 256
ethmode <auto | 10hd | 10fd | 100 fd | 100hd>
Set the Ethernet speed and duplex.
auto - Auto-negotiate
10hd - 10Base-T Half Duplex
10fd - 10Base-T Full Duplex
100hd - 100Base-T Half Duplex
100fd - 100Base-T Full Duplex
fastreg <off | on>
Enable or disable fast registration mode.
fixframe <off|on>
Enable or disable the fixed frame mode.
off - Use dynamic frames based on traffic patterns.
on - Wireless frames are fixed at the size specified in the framesize field.
framesize <size>
Set the frame size (1 - 20 ms) (when Fixed Frame is enabled).
size - Enter the fixed frame size (ms).
gateway <ip>
Set the IP address of the default gateway on this segment.
gmt <value>
Set the time offset from GMT (e.g., -5 for EST).
grpcir <id> <50 - 50000>
Set the Service Group Committed Information Rate (CIR) for downlink broadcast and
multicast traffic.
id - Group ID number.
grpdot1p0 <id> <queue>
Assign a queue for Ethernet packets with priority 0 (default is 0).
id - Service ID number.
queue - Assign queue (0-3).
grpdot1p1 <id> <queue>
Assign a queue for Ethernet packets with priority 1 (default is 0).
id - Service ID number.
queue - Assign queue (0-3).
grpdot1p2 <id> <queue>
Assign a queue for Ethernet packets with priority 2 (default is 1).
id - Service ID number.
queue - Assign queue (0-3).
grpdot1p3 <id> <queue>
Assign a queue for Ethernet packets with priority 3 (default is 1).
id - Service ID number.
queue - Assign queue (0-3).
70-00158-01-08
USER MANUAL
Proprietary Redline Communications © 2011 Page 110 of 150 December 7, 2011