Redline RDL-3000 SC User Manual page 113

RDL-3000 FAMILY
value - Distance (Km) to farthest subscriber.
maxtxpower <value> <rf1 | rf2>
Set the Tx power level (dBm). This setting is for the transceiver output only. The
actual EIRP depends on the gain of the connected antenna. The maximum value is
controlled by the options key.
value - Enter the Tx power (-10 to 22).
rf1 - Set the power for RF port 1.
rf2 - Set the power for RF port 2.
mgmtag <off | on>
Enable or disable the HTTPS function. See also mgmvid.
off - Do not use VLAN to identify management traffic.
on - Enable VLAN tagged management traffic. See mgmvid.
mgmvid <1 - 4095>
Enter the Management VLAN ID. See also mgmtag.
vlan_id - Management VLAN ID.
netmask <mask>
RDL-3000 IP netmask in standard format.
optionskey <optkey> <actkey>
Enter the options key followed by the key position (0 or 1) to save the key. This
command works silently to validate, save, and activate the key. Event messages are
logged for each of these operations. Advance notice is provided when a temporary
options key is about to expire.
optkey - Enter a new options key.
actkey - Specify the active options key (position 1 or 2).
peermac <MAC>
MAC address of the communicating RDL-3000. Required for wireless encryption
(e.g., 00:05:5d:e0:5b:10
pskey <key>
Enter the encryption key to be shared between the sector controller and all
subscribers in this sector. This is required only when encryption is enabled.
radio <off | rf1 | rf2 | rf1rf2>
Enable or disable the radio transmitter.
radius <ip | mode | port | retries | secret | timeout>
Configure the RADIUS server. The first parameter for all commands must be the
radius server identifier (1 or 2):
ip <1 | 2> <IP address>
IP address of RADIUS server.
70-00158-01-08
For example: set netmask 255.255.255.0
off - Disable both radios
rf1: Use only radio 1 (SISO mode).
rf2: Use only radio 2 (SISO mode).
rf1rf2: Use radio 1 and radio 2 (MIMO mode).
1 - Primary RADIUS server.
Proprietary Redline Communications © 2011
USER MANUAL
Page 113 of 150 December 7, 2011