Redline RDL-3000 SC User Manual page 111

RDL-3000 FAMILY
grpdot1p4 <id> <queue>
Assign a queue for Ethernet packets with priority 4 (default is 2).
id - Service ID number.
queue - Assign queue (0-3).
grpdot1p5 <id> <queue>
Assign a queue for Ethernet packets with priority 5 (default is 2).
id - Service ID number.
queue - Assign queue (0-3).
grpdot1p6 <id> <queue>
Assign a queue for Ethernet packets with priority 6 (default is 3).
id - Service ID number.
queue - Assign queue (0-3).
grpdot1p7 <id> <queue>
Assign a queue for Ethernet packets with priority 7 (default is 3).
id - Service ID number.
queue - Assign queue (0-3).
grpdot1pena <id> <mode>
Enable or disable 802.1p services for this Group.
id - Group id number
mode - Enter the mode:
grppir <id> <50 - 50000>
Set the Service Group peak information rate (PIR) (Kbps). Applies to uplink and
downlink traffic.
id - Group ID number.
grppri <id> <pri>
Set the Service Group default priority.
id - Group reference ID number.
pri - Group 802.1p priority setting (0-7).
grprate <id> <rate>
Set the Service Group maximum rate (Mbps). Applies to uplink and downlink.
id - Group reference ID number.
rate - 0-7 (MCS), or auto.
grpvid <id> <vid>
Enter the VLAN ID for this Service Group (if tagging enabled).
id - [id number]
vid - VLAN ID
grpviden <id> <off | on>
Enable or disable this Service Group.
id - [id number]
70-00158-01-08
USER MANUAL
off - Disable
on -Enable
Proprietary Redline Communications © 2011 Page 111 of 150 December 7, 2011