RDL-3000 FAMILY
2.2.4
Setting Wireless Rates
The wireless bandwidth is shared between all subscribers in a sector. Use the following
settings to control traffic rates over the wireless interface.
Type
Link
Service
Service
Group
Notes:
Unicast traffic with an unknown destination (all RDL-3000 units maintain a forwarding
1.
table) is transmitted two modulation steps below the lowest rate currently in-use
across all active Services.
70-00158-01-08
USER MANUAL
Table 6: Web - Operation - Wireless Rates
Function
Set the Uncoded Burst Rates (UBR)
for uplink and downlink traffic to and
from this subscriber. This rate is
shared across all Services and
Service Groups.
Set the uplink and downlink rates (per
Service) for unicast traffic to and from
this subscriber.
Set the downlink rates (per Service
Group) for multicast and broadcast
traffic sent to members of this group.
Fig. 7: Function - Wireless Rates
Proprietary Redline Communications © 2011
Wireless Settings
Downlink UBR
Uplink UBR
Adaptive modulation mode
Downlink CIR / PIR
Uplink CIR / PIR
Downlink Burst rate
Downlink CIR / PIR
Page
23
of 150
December 7, 2011