RDL-3000 FAMILY
Frequency Management Screen
Click
Configuration->Wireless->Frequencies
screen. Use this screen to create frequency lists for subscribers to quickly locate and re-
register with the sector controller. Up to 32 frequency ranges may be entered.
Following any subscriber power-cycle, reboot, or temporary loss of the wireless link
(e.g., transient interference) the subscriber first checks any frequencies in the Local
Frequency Ranges table. If a sector controller is not located, then the subscriber scans
all available frequencies.
IMPORTANT: The Auto scan feature must be enabled on the subscriber to use the
frequency lists. If Auto scan is disabled, the subscriber only monitors the channel
selection in the RF Frequency field.
Add
Enter the start and end frequency for this range. The subscriber automatically
compensates for channel size when selecting center frequencies.
Begin: Lower limit of the frequency range to scan.
End: Upper limit of the frequency range to scan.
Add: Click to save the displayed range settings (Local Frequency Range table). The
range entered is not checked for validity until the Apply button is clicked.
Delete
Index: Choose the index of the frequency range to be deleted.
Delete: Click to permanently remove the selected frequency range.
Local Frequency Ranges
The entries in this table are saved in non-volatile memory and are loaded when the
unit is power-cycled/rebooted.
Index: Index of this entry in the Local Frequency Range table.
Begin: Lower limit of the frequency scan interval (MHz).
End: Upper limit of the frequency scan interval (MHz).
70-00158-01-08
USER MANUAL
Fig. 40: Web - Frequency Management Screen
Proprietary Redline Communications © 2011
to display the Frequency Management
Page
68
of 150
December 7, 2011