Redline RDL-3000 SC User Manual page 109

RDL-3000 FAMILY
Set a Link to this Service connection.
id - Service ID number.
lid - Link ID number.
conpri <id> <0 - 7>
Set a VLAN default priority for this Service or Service Group connection.
convid <id> <1 - 4095>
Set the VLAN address for this Service or Service Group connection.
id - Service reference ID number.
conviden <id> <off | on>
Enable or disable VLAN for this Service or Service Group connection..
id - Service ID number.
on - VLAN is enabled.
off - VLAN is disabled.
dfsaction <none | txoff | chgfreq>
Select the mode of operation for DFS. Enter only the text or the number.
None (0): The DFS function is disabled.
Tx Off (1): Transmission is immediately disabled when radar signals are
detected. This action is recorded in the message log and an SNMP trap
message is sent (if SNMP enabled).
Chg Freq (2): Relocate transmission to an alternative frequency immediately
when radar signals are detected. This action is recorded in the message log
and a trap message is sent (if SNMP enabled).
dlcir <id> <50 - 50000>
Set the downlink committed information rate (CIR) (Kbps).
id - Service ID number.
dlpir <id> <50 - 50000>
Set the downlink peak information rate (PIR) (Kbps).
id - Service ID number.
dlrate <id> <rate>
Link maximum downlink uncoded burst rate.
id = Link ID number.
rate - Minimum downlink rates in MCS (modulation coding scheme).
dlratio <20-80>
Set the downlink ratio.
encmode <0 - 4>
Set the encryption mode. The same encryption level must be selected on
communicating systems.
0 - Disable
1 - AES 128
2- AES 192
70-00158-01-08
USER MANUAL
SISO/MIMO-A mode - 0 - 7
MIMO-A/MIMO-B mode - 0 - 15
Proprietary Redline Communications © 2011 Page 109 of 150 December 7, 2011