RDL-3000 FAMILY
3.3 Dashboard Display
General Information
The dashboard is displayed at the top of all Web screens.
IP Address: IP address of this unit.
Wireless Frequency: RF frequency in-use by this unit.
Time: Local time obtained from the Web browser (not the RDL-3000 clock time).
Test time: Visible only when the
at any time to cancel the timer and permanently save the running configuration. The last
saved configuration is restored when the counter reaches zero (unit is not rebooted).
Unsaved Data: Indicates if the configuration has been modified.
No: There are no differences between the running and saved configurations.
Saving: The system is saving the runtime parameters to non-volatile RAM.
Yes: There are unsaved changes to the configuration. Click
to permanently save the current running configuration. Unsaved settings are discarded
when the system is power-cycled or rebooted.
Radio Temperature: Internal temperature of the radio. The normal internal operating
temperature is between -35° C and 70° C.
Wireless Leds
The Wireless LED indicators indicate the status of the wireless link.
Link
This LED is not implemented in the current software release.
Signal
Adaptive Modulation is disabled:
Off:
On:
Adaptive Modulation is enabled:
Off:
Blink:
On:
Ethernet LEDs
These LED indicators provide a summary of the Ethernet port status.
Link
Off:
On:
100
Off:
On:
FD
Off:
On:
70-00158-01-08
USER MANUAL
Fig. 19: Web - Dashboard Display
Test
Table 8: Web - Wireless LED Indications
Wireless link has not been established. The remote end may be powered off or
the link can not be established at the required modulation/coding.
Wireless link has been established at the modulation/coding corresponding to
the required UBR.
Wireless link has not been established. The remote end may be powered off.
Current modulation/coding is too low to meet the minimum required UBR.
Current modulation/coding meets or exceeds the minimum required UBR.
Table 9: Web - Ethernet LED Indications
Ethernet connection is not detected (e.g., Ethernet cable faulty / disconnected).
Ethernet link is detected.
Ethernet port is operating at 10 Mb/s.
Ethernet port is operating at 100 Mb/s.
Ethernet connection is operating in half-duplex mode.
Ethernet connection is operating in full-duplex mode.
Proprietary Redline Communications © 2011
function is active. Click
Page
Save All
in the main menu
Save All
in the main menu
36
of 150
December 7, 2011