Pmp Configurations; Vlan Services; Default Groups And Services; Fig. 11: Function - Vlan Services: Default Groups And Services - Redline RDL-3000 SC User Manual

RDL-3000 FAMILY
2.2.8

PMP Configurations

This section describes basic configurations for an RDL-3000 PMP system.

VLAN Services

Default Groups and Services

The RDL-3000 may be configured to use VLAN to manage separate services.
In the following example, all voice traffic is separated from data traffic, allowing specific
CIR and PIR value to be set for this traffic. All traffic not classified to the Voice Service
Group is processed by the Data Group (Pass through mode). The Voice Group and
member Services are configured for tagged traffic. The VLAN tag (VID=3) is removed
from packets received from the wired network and restored when the packet is
forwarded on the remote wired network (both directions). The Data Group and Services
are configured for Pass-through mode and packets are forwarded unmodified to the
destination port.

Fig. 11: Function - VLAN Services: Default Groups and Services

Notes:
This configuration does not enforce a Service Group to have a Service on every
1.
subscriber.
The private network may be isolated by disabling the Ethernet port (SC Ethernet Port
2.
Enable
70-00158-01-08
USER MANUAL
) on the sector controller.
Proprietary Redline Communications © 2011 Page 27 of 150 December 7, 2011