Ptp Mode; Fig. 16: Function - Ptp Mode Configuration - Redline RDL-3000 SC User Manual

RDL-3000 FAMILY

2.3 PTP Mode

The RDL-3000 can be configured to operate as a point-to-point (PTP) VLAN-aware
wireless L2 switch, with traffic being classified and forwarded based on the packet VID.
Each classification includes CIR/PIR settings to guarantee required bandwidth. The
RDL-3000 also provides a 'Pass through' classification to forward traffic not matched to
any classifier.
PTP mode is enabled by the options key. Enter a PTP-enabled options key before
deploying and configuring the RDL-3000 units. The options key enables specific PTP
options, including restricting operation to a single remote subscriber and a PTP-specific
range of RF power settings. One unit must be configured as a sector controller (PMP
SC) and the second unit as a remote (PMP SS).
Notes:
Service Group and Service CIR and PIR settings should be set to enable the
1.
maximum throughput.
The remote unit (SS) can be managed over the air from the sector controller (SC),
2.
but the SC can only be managed using the local Ethernet port (security restriction).
70-00158-01-08
USER MANUAL

Fig. 16: Function - PTP Mode Configuration

Proprietary Redline Communications © 2011 Page 32 of 150 December 7, 2011