RDL-3000 FAMILY
Power-off the RDL-3000 PoE adapter for 5 seconds.
3.
Restore power to the RDL-3000 PoE adapter.
4.
Wait 75 seconds, then press the ENTER key on the PC to start the Telnet session.
5.
When the login prompt appears, you have a window of 30 seconds to login using the
default username (admin) and password (admin).
If a login prompt does not appear, re-enter the Telnet command during the 30
second interval. If this is not successful, repeat steps 1 to 4 using an initial wait time
of 70 to 90 seconds).
Note: If the operator does not login during this step, the RDL-3000 reboots
automatically after 30 seconds and is operational after an additional 75 seconds.
When login is successful, the admin and user accounts are reset to the factory
6.
default usernames and login values and all other user accounts are deleted. No
other parameters are changed. All standard configuration commands are now
available to the operator. If the IP was unknown, this can be now displayed and/or
changed. Modify settings as required and reboot the RDL-3000 to exit from long
reset mode.
Web
If using a web browser to access the RDL-3000, prepare the PC for by opening a Web
browser on the PC and typing the following URL into the address bar:
http://192.168.25.2
Follow the steps for 'Long Reset Using Telnet', substituting the Web browser for Telnet.
Restore Default Passwords Only
Use this procedure if the unit IP address is known and it is desired only to restore the
default usernames and passwords. All other configuration settings are preserved.
Telnet
Perform a long reset and use Telnet to login to the RDL-3000 using the default IP
1.
address (192.168.25.2) and the default login credentials (admin/admin).
Enter the command reboot to restart the unit. Do not enter any other commands.
2.
Login to the RDL-3000 using the user-configured IP address and the default
3.
administrator username (admin) and password (admin).
Web
Perform a long reset and use a Web browser to login to the RDL-3000 using the
1.
default IP address (192.168.25.2), and the default administrator username (admin)
and password (admin).
Click Configuration->System to display the System Configuration screen.
2.
Click on the Reboot buttons at the bottom of the screen to reboot the RDL-3000.
3.
Login to the RDL-3000 using the user-configured IP address and the default
4.
administrator username and password (admin/admin).
70-00158-01-08
USER MANUAL
Proprietary Redline Communications © 2011
Page
129
of 150
December 7, 2011