Snmpcommunity; Snmptrap - Redline RDL-3000 SC User Manual

RDL-3000 FAMILY
4.3.21
Use the snmpcommunity command to configure SNMP community permissions.
snmpcommunity <add> <clearall> <default> <del> <print>
add <name> <rights>
Add a new SNMP community to the SNMP community table. The index value is
assigned automatically. Up to eight community entries can be entered.
name
Enter the SNMP community name.
rights
Specify the rights for this community string. Where.
clearall (no parameters)
Delete all SNMP parameters.
default <idx>
Set all SNMP parameters to factory default settings.
del <idx>
Delete the specified community entry.
print
List all SNMP communities and associated permissions.
4.3.22
Use the snmptrap command to configure the SNMP trap message reporting.
snmptrap <off | on> <add> <change> <clearall> <del> <print>
add <ipaddr> <port> <identity>
Create up to eight SNMP traps. The index value is assigned automatically.
ipaddr
port
identity
change <idx> [-p <port>] [-i <ip_add>] [-c <community>] [-u username]
Modify the specified SNMP setting.
idx
-i <ip_add>]
-p <port>]
-c <community> Enter associated SNMP community string (SNMP V1 or v2).
70-00158-01-08

snmpcommunity

0: Deny read and write permission (enter zero).
r: Grant read access permission only.
w: Grant write access permission only.
rw: Grant read and write access permission.
idx Specify single entry to be set to default (use 'print' command to
display ids).
idx Specify single entry to be deleted (use 'print' command to display
ids).

snmptrap

Enter destination IP address
Enter destination port address.
v2: Enter associated SNMP community string.
v3: Enter account username for authorization.
Index of the SNMP trap (use 'print' command to display ids).
Enter destination IP address.
Enter destination port address.
Proprietary Redline Communications © 2011
USER MANUAL
Page 121 of 150 December 7, 2011