Redline RDL-3000 SC User Manual page 108

RDL-3000 FAMILY
antbeam <0-n>
Set the operating mode for the RAS smart antenna.
0:
1-n:
antgain <gain>
Set the antenna gain (used for DFS).
<gain> Enter gain in dBi.
autoscan <off | on>
Enable or disable the Autoscan function. When enabled, the Subscriber
automatically scans available channels to locate the current operating frequency.
off - Disable
on - Enable
bsmac <mac_address | 00:00:00:00:00:00>
Enter the sector controller MAC address to allow this subscriber to register only with
that device. Enter 00:00:00:00:00:00 to allow the subscriber to connect to any
available sector controller (e.g., when using the optional STID template feature).
bsporten <id> <off | on>
Enable and disable sector controller Ethernet port for a Service Group.
id - ID of Service Group.
off - Disabled
on - Enabled
buzzer <off | on>
Enable or disable the audible alignment buzzer. When enabled, the rate of the tone
is proportional to the receive signal strength (faster rate = stronger signal).
off - Disable
on - Enable
chsize <bandwidth>
Set the channel bandwidth (enabled by options key).
bandwidth - Enter bandwidth in MHz (e.g., 20).
chwidth <bandwidth>
Set the channel bandwidth (enabled by options key).
bandwidth - Enter bandwidth in MHz (e.g., 20).
congid <id> <gid>
Set a Service Group to this Service.
id - Service ID number.
gid - Service Group ID number.
conlid <id> <lid>
70-00158-01-08
off - Disable
on - Enable
The RAS smart antenna automaticallys scan 360° in azimuth to locate
signals from Redline sector controllers. Refer to the 'autoscan'
command.
Manually set the RAS smart antenna beam to the specified sector. The
center of sector '1' is marked on the antenna. The remaining sectors are
arranged sequentially counter-clockwise around the antenna.
Proprietary Redline Communications © 2011
USER MANUAL
Page 108 of 150 December 7, 2011