Redline RDL-3000 SC User Manual page 40

RDL-3000 FAMILY
1-n:
Current CIR Subscription Ratio: (SC only) Traffic loading is determined by comparing
the available bandwidth to the committed bandwidth. This value is calculated for all links
in the sector.
0-100%: Current scheduling commitments can be achieved under the present
>100%: The unit is oversubscribed (aggregate of CIR requests exceeds available
Wireless Security: Status of the wireless security selection.
Off - No wireless security.
On - Data sent over the wireless interface is encrypted.
DFS: Status of the DFS function.
Off: The DFS function is disabled.
On: DFS function is activated. See
DFS Action: The avoidance action to be taken when radar signals are detected. All DFS
actions are recorded in the event log.
None: The DFS feature is disabled.
Tx Off: Radio transmitter is disabled for 30 minutes.
Chg Freq: Radio transmitter is changed to a different RF frequency.
Status Code: Code indicating the status of the RDL-3000 system. Code '0000 0000'
indicates normal operation. Refer to the troubleshooting section of this manual.
Enhanced Video Buffer: Status of the enhanced video feature. This subscriber key-
enabled feature allows the use of multiple high-definition cameras on a wireless link.
Off - There are no subscribers with the enhanced video feature enabled.
On - One or more subscribers has the enhanced video feature enabled.
GPS Status: (SC only) Display the status of the internal GPS unit.
N/A: The GPS device is not installed (or is malfunctioning).
No Signal: There is no signal detected on the PPS port.
Locked: The RDL-3000 internal clock is synchronized.
Synchronization Status: (SC only) Display the synchronization status.
N/A: This message is displayed for the following conditions:
a) Synchronization mode is disabled.
b) Synchronization mode is enabled and PPS port is disabled.
No Signal: There is no signal on the PPS port.
Acquiring: A PPS signal is detected and the internal clock is being synchronized.
Locked: The internal clock is synchronized to the PPS signal.
Redundancy Status: Status of the sector controller redundancy feature. This is a key-
enabled option for the sector controller.
Off - Redundancy feature is disabled.
Primary Active - This unit is Backup and peer Primary SC is active.
Primary Inactive - This unit is Backup and peer Primary SC is not responding.
Backup Active - This unit is Primary and peer Backup SC is active.
70-00158-01-08
USER MANUAL
Antenna is set for the specified sector. The center of sector '1' is marked
on the antenna. The remaining sectors are arranged sequentially
counter-clockwise around the antenna.
operating conditions (e.g., surplus bandwidth is available).
bandwidth).
Proprietary Redline Communications © 2011
below.
DFS Action
Page 40 of 150 December 7, 2011