New; Ping; Reboot; Reset - Redline RDL-3000 SC User Manual

RDL-3000 FAMILY
4.3.13
Use the new command to create a new Service Group, Service, or Link.
Mapping
Groups, and Services created using CLI (manually or using 'load script') do not
appear on the Web interface until they are set to 'enabled'.
new <conn> <group> <link> <service>
conn <id>
Create a new Service. Equivalent to 'new service <id>' This command is provided to
support migration from AN-80i systems.
id - Specify a unique ID for this new service.
group <id>
Create a new Service Group.
id - Specify a unique ID for this new Service Group.
link <id>
Create a new Link.
id - Specify a unique ID for this new Link.
service <id>
Create a new Service.
id - Specify a unique ID for this new Service.
tplink <id>
Create a new link template for use with the STID feature. Use the same commands
applicable to configuring a standard link.
id - Specify a unique ID for this new link template.
4.3.14
Use the ping command to initiate an ICMP ping command from the RDL-3000. This can
be used to confirm network access to FTP/TFTP servers, syslog servers, etc.
ping <IP address> <Number of Packets> <Length>
IP address
Number of Packets Number of ICMP packets to send (1 to 16).
Length
4.3.15
Use the reboot command to reboot the RDL-3000 firmware.
reboot <delay>
delay Number of seconds to wait before rebooting (60 max.).Enter 'reboot 0'
Note: Use this command in combination with Apply to temporarily test changes to the
configuration. For example:

reboot 60

apply
{ test changes}
reboot 0
4.3.16
Use the reset command to zero the RDL-3000 statistics or ID table.
reset <stats>
Clear statistics counters.
70-00158-01-08
USER MANUAL

new

for the valid ID ranges for each type. Note that new Links, Service

ping

IP address of target.
Not supported in this software release.
reboot
(zero) to cancel a pending reboot.
Schedule reboot in 1 minutes
Activate configuration changes (without saving)
Cancel reboot

reset

Proprietary Redline Communications © 2011 Page 106 of 150 December 7, 2011
See ID