Advanced Wireless Configuration; Fig. 38: Web - Wireless Configuration Screen -- Subscriber - Redline RDL-3000 SC User Manual

Rdl-3000 family broadband wireless radio platforms
Hide thumbs Also See for RDL-3000 SC:
Table of Contents

Advertisement

RDL-3000 FAMILY

Advanced Wireless Configuration

Max. Distance [km]: (SC only) Enter the distance to the subscriber located farthest from
the sector controller. The distance may be entered in miles or kilometers.
DFS Action: (SC only) Select the mode of operation for DFS. The sector controller
monitors for interference from radar devices and other equipment using the same
channel frequency. When interference is detected, the unit automatically performs the
selected action:
None: The DFS function is disabled. Where DFS is required by regional regulations,
this feature is permanently enabled at the factory and can not be disabled by the
installer or end-user.
Tx Off: When radar signals are detected, the transmitter is immediately switched off,
an event message is logged, and configured SNMP trap messages are sent. After
thirty minutes the unit monitors the RF channel for one minute. If radar signals are
detected, the transmitter remains disabled and the unit waits thirty minutes before
repeating the monitoring period. Normal operation resumes only when radar signals
are not detected during a one minute monitoring period.
Chg Freq: When radar signals are detected, the transmitter is immediately switched
off, an event message is logged, and configured SNMP trap messages are sent. The
unit changes frequency and monitors the new RF channel for one minute. If radar
signals are detected during the monitoring period, the transmitter remains disabled
and the unit switches to the next frequency to be tested. Normal operation resumes
only when radar signals are not detected during a one minute monitoring period.
Antenna Gain: Enter the antenna gain specified by the manufacturer. This field is
required only when the DFS Action is set to Tx Off or Chg Freq.
IMPORTANT: It is important to enter the gain value specified by the manufacturer. If the
gain is set lower the RDL-3000 will be more sensitive to interference and this may cause
70-00158-01-08
USER MANUAL

Fig. 38: Web - Wireless Configuration Screen -- Subscriber

Proprietary Redline Communications © 2011
Page
63
of 150
December 7, 2011

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Rdl-3000 suRdl-3000 mEnterprise

Table of Contents