Redline RDL-3000 SC User Manual page 118

Rdl-3000 family broadband wireless radio platforms
Hide thumbs Also See for RDL-3000 SC:
Table of Contents

Advertisement

RDL-3000 FAMILY
Enter contact descriptive for this unit. Enter up to thirty (30) alpha-numeric
characters including a-z, A-Z, 0-9, dash (-), and underscore (_).
sysdescr <text>
Enter system description for this unit. Enter up to thirty (30) alpha-numeric
characters including a-z, A-Z, 0-9, dash (-), and underscore (_).
sysloc <location>
Enter location description for this RDL-3000 location. Enter up to thirty (30) alpha-
numeric characters including a-z, A-Z, 0-9, dash (-), and underscore (_).
syslog <off | on>
Enable or disable using a syslog service.
off - Disable syslog server protocol support.
on - Enable syslog server protocol support.
syslogip <ip>
Set the syslog server IP address. Valid only if syslog is enabled.
sysmode <pmpsc | pmpss>
Set the operational mode.
pmpsc - The sector controller begins transmitting automatically; sending poll
messages to locate the remote subscribers (pmpss).
pmpss - Each subscriber monitors the selected channel(s) and responds
only when polled by the sector controller.
sysname <text
Enter the name for this unit (any combination of up to 20 letters and numbers).
telnet <off | on>
Enable or disable the Telnet port (CLI interface).
off - Disable
on - Enable
Changes to this field are effective only following reboot.
telnetport <1 - 65535>
Set the Telnet port address. Changes are effective only after a reboot.
port - Limits for the telnet port are 22..79 and 81..65534 (default is 23).
ulcir <id> <50-50000>
Set the uplink committed information rate for the service (Kbps).
id - [id number]
ulminrate <id> <rate>
Set the Link minimum uplink uncoded burst rate (Mbps. Values are dependent on the
channel bandwidth (set chsize/set chwidth).
id - Link ID number.
rate - Minimum downlink rates in MCS (modulation coding scheme).
ulpir <id> <50 - 50000>
Set the Service uplink peak information rate (PIR) (Kbps).
70-00158-01-08
USER MANUAL
SISO/MIMO-A mode - 0 - 7
MIMO-A/MIMO-B mode - 0 - 15
Proprietary Redline Communications © 2011
Page
118
of 150
December 7, 2011

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Rdl-3000 suRdl-3000 mEnterprise

Table of Contents