3. INSTALLATION
3.4 SSCNET III cable connection
(1) SSCNET III cable connection
For the CN1A connector of MR-MT2010, connect the SSCNET III cable connected to a controller, a
servo amplifier at the previous station, or the head module of the sensing module. Put an accessory cap
to the CN1B connector of the servo amplifier or the head module of the sensing module in the final
station.
SSCNET III cable
Controller
POINT
Do not look directly at the light emitted from the CN1A and CN1B connectors of
the MR-MT2010 and the end of the SSCNET III cable. The light can be a
discomfort when it enters the eyes.
Servo amplifier
Sensing module
SSCNET III
cable
CN1A
CN1B
3 - 8
Sensing module of
the last station
SSCNET III
cable
CN1A
CN1B
CN1A
Cap
CN1B