Selection Example Of Wires - Mitsubishi Electric MR-J5 Series User Manual

6.8

Selection example of wires

To comply with the IEC/EN/UL/CSA standard, use the wires indicated below. To comply with other standards,
use wire that complies with each standard.
MR-J5-G/MR-J5W-G User's Manual (Introduction)
MR-J5-A User's Manual (Introduction)
Refer to the following for a selection example of when the MR-J5 servo amplifier is used with the DC power
supply input.
Page 26 Using servo amplifier with DC power supply input
Selection conditions of wire size are as follows.
Construction condition: Single wire set in midair
Wiring length: 30 m or shorter
The following shows the wires used for wiring. Use the wires given in this section or equivalent wires.
Power supply
2) Control circuit
power supply lead
5) Power regeneration converter lead
Power regeneration
converter
6 OPTIONS AND PERIPHERAL EQUIPMENT
166
6.8 Selection example of wires
1) Main circuit power supply lead
Regenerative option
3) Regenerative option lead
Servo amplifier
L1
U
L2
V
L3
W
L11
4) Servo motor power lead
L21
N
-
C
P
+
M